+- nD-enerserve Forums (https://forum.enerserve.eu)
+-- Forum: SmartPi (https://forum.enerserve.eu/forumdisplay.php?fid=1)
+--- Forum: SmartPi - English (https://forum.enerserve.eu/forumdisplay.php?fid=2)
+--- Thread: DIN rail install (/showthread.php?tid=3)
DIN rail install - SuperQ - 26.04.2017
Just to warm up the English section, here's some photos of my SmartPi install in a DIN rail case.
The case:
https://www.amazon.de/gp/product/B01EB5YEB0
The PSU:
https://www.amazon.de/gp/product/B00MWQEBAU
I very carefully modified the case to allow the SmartPi to be mounted.
I ended up doing some careful boring to drill out the mounting holes on my RPi and SmartPi board to allow for 3mm threading. This worked better than the included 2.5mm standoffs because the case used 3mm mounting holes.
I used 18mm standoffs, but 20mm would also have worked.
https://goo.gl/photos/Xsd1yrtzhdwJWdP46