Since yesterday, after a power failure, the shown power values are inversed.
My consumption is shown as a negative value, and the production from my solar panels is shown as positive values.
So I needed to switch the direction of the current measurements.
Why is this happening? I connected the current coils over the main leads with the arrows in the direction of my home.
In your documentation there is a drawing of the connections of these coils. You can see that the arrows on the coils are from the left to the right, so in fact from the house to the power net.
Is this correct? Because I suppose the current direction should be from the power net to the house. So I believe the arrows are drawn in the wrong direction.
Since the documentation is very poor about this, give me a clear answer or drawing how to connect the current coils over the wires in a correct way.
My consumption is shown as a negative value, and the production from my solar panels is shown as positive values.
So I needed to switch the direction of the current measurements.
Why is this happening? I connected the current coils over the main leads with the arrows in the direction of my home.
In your documentation there is a drawing of the connections of these coils. You can see that the arrows on the coils are from the left to the right, so in fact from the house to the power net.
Is this correct? Because I suppose the current direction should be from the power net to the house. So I believe the arrows are drawn in the wrong direction.
Since the documentation is very poor about this, give me a clear answer or drawing how to connect the current coils over the wires in a correct way.
